How To Fit A SUPER SEAL Waterproof Wire Connector – Easy Step-by-Step Assembly Guide!

View Original Post for complete content...

A step-by-step guide on how to assemble and fit a Super Seal Waterproof Wire Connector - no special tools required, just a pair of scissors and a set of pliers! These are fantastic 12V wire connectors for use in damp or wet environments and are widely used in automotive and marine electrical systems - great for incorporating into Car, Bike, Camper Van, Caravan, Truck, Boat and Kayak electrics. These connectors make it easy to disconnect and re-connect power to a device when needed. I personally use these within kayak electrics specifically within fish finder set ups to make it easy and quick to disconnect a 12V battery. Shown in the video is the Tyco AMP Superseal 1 Pin Connector, but the same process of installation is used for the 2-pin, 3-pin, 4-pin etc. connectors too. Apologies for the slight blur when holding the small components close to the camera - it struggled to get these little parts into focus! SUBSCRIBE to my channel for more kayak fishing rigging and DIY! #sup.... Continue Reading at Kayak Fishing Blog

Do NOT follow this link or you will be banned from the site!